6109 Highway A1A, Melbourne Beach, FL Just Listed for $1.5 Million

6109 Highway A1A, Melbourne Beach

The DeWayne Carpenter / Kirk Kessel Homeselling Team just listed the property at 6109 Highway A1A, Melbourne Beach for $1.5 Million


Ideally situated on over 1/2 acre with 270 degrees of the property surrounded by preserve. The property is situated in such a way you have unobstructed Atlantic or Intracoastal views from every room of the house. Sitting on a deep lot allows for a pool in the backyard which is very hard to come by in Melbourne Beach. This custom built residence takes advantage of the premium lot with an abundant amount of impact windows and doors AND three separate marble balconies. The quality of the residence is unsurpassed and over engineered.

South View Overlooking the Preserve

South View Overlooking the Preserve


A true jewel by the sea is found in this timeless West Indies-inspired estate, directly fronting the Atlantic Ocean and surrounded by 270 degrees of preserve. The luxurious custom four-bedroom, four bath residence is filled with a wealth of exquisite finishes. Impressive elegance and comfortable warmth blend in perfectly scaled rooms equally attuned to entertaining and everyday living. In addition to the principal living areas on the main level located on the 2nd floor, there is a lower-level guest suite with it’s own kitchen and living area. The master suite and additional guest suite is located on the 3rd floor with jaw-dropping views from both east and west balconies.
Ocean views take center stage in the light-filled, window-walled living room and kitchen, opening to the magnificent marble outdoor balcony, where the vista is all the more alluring. The beach beckons down the private pathway through the lush dunes. While secluded in its own serene oceanfront oasis, this choice property is well located only a few miles from the Driftwood plaza for all your everyday conveniences and 30 mintues to Vero, which is gaining the reputation of being “The Hamptons” of South Florida.

Additional upgrades in this 2010 built home

  • All trusses double strapped
  • All trusses 2X6 – above code
  • Plywood on roof screwed (not nailed) with stainless steel screws and adhesive to trusses
  • All block is poured and filled – all treated with anti-rust treatment for steel
  • Grade beam and piles throughout
  • Two tankless heaters handling different zones
  • All spray foam insulation in attic, trusses and subfloors
  • First floor elevation was raised to future code standards 
  • Elevator shaft in place for future including false floors and racing
  • Electric in place for panel for future elevator
  • Gas in place for future pool heater
  • All gray beam construction with non-rust sealant and spray